![background image](http://html1.mh-extra.com/html/crux/my22/my22_user-manual_2691639005.webp)
2
2. GENERAL NOTES ABOUT ASSEMBLY
This manual is not intended as a comprehensive assembly, use, service, repair or maintenance
guide. Please see your Authorized Specialized Retailer for all service, repairs, or maintenance.
Your Authorized Specialized Retailer may also be able to refer you to classes, clinics, or books
on bicycle use, service, repair, and maintenance.
Tire sizes vary significantly from brand to brand. CEN standards require a minimum of 6
mm of clearance between the frame/fork and the tires. When choosing a wheel and tire
combo, factor in enough clearance for the conditions, setup and wheel flex.
The CruX frames use a 68 mm standard BSA threaded design. Grease the threads. Install
and torque according to the bottom bracket manufacturer’s instructions.
Before installing the bottom bracket and crank, make sure all housings and wires are
routed through the frame.
In order to successfully build the CruX bicycle, it is very important to follow the
order of operations as outlined in this manual. Modifying the order of assembly
will result in a longer build process.
Assembly of the front end of the bicycle is easiest with the rider’s fit already
determined (the steerer tube doesn’t need to be cut at this time, it can stick
out the top of the stem), prior to routing all the housings and wires through the
frame and fork.
To determine fit, it is recommended to use a fit tool. If this is not possible,
perform a basic assembly of the wheels, drivetrain and front-end components,
without the brakes and housings. Once the fit is complete, all the components
will have to be removed in order to route the housings and wires.
WARNING! Due to the high degree of complexity of the CruX, proper assembly
requires a high degree of mechanical expertise, skill, training and specialty tools.
Therefore, it is essential that the assembly, maintenance and troubleshooting be
performed by an Authorized Specialized Retailer.
CAUTION: Do not face the bottom bracket shell! This can prevent proper
installation of the crank. Your Specialized frame does not require any bottom
bracket shell pre-installation preparation, as all surfaces have been precisely
machined to specific tolerances at the factory for proper interface with a
compatible crankset. Please refer to the manufacturer instructions for crank
and bottom bracket installation.
CAUTION: Always use a bottom bracket equipped with a sleeve between the
two cups. Running a bottom bracket without the sleeve can result in housings
and/or wires contacting the bottom bracket spindle, which can result in wear.
Summary of Contents for MY22
Page 1: ...USER MANUAL ENGLISH ...
Page 2: ......
Page 14: ...11 1 CHURRO Foam sleeve S179900013 S179900013 5 4 DISC BRAKES ...