13
10. Angle the jug so that the tip of the steam wand is sitting right below the surface of
the milk. This will cause the milk to begin to create a whirlpool effect.
11. Then fully submerge the steam wand into the milk to continue to heat it up, you will
know when the milk is hot enough because the jug will be extremely hot to touch.
Do not boil the milk or this will spoil the flavour.
12. Once the jug has fully heated, turn the control dial to the OFF position ( ).
13. Remove the jug from the steam jet.
14. Let the milk rest.
15. Wipe the steam wand with a damp cloth to clean.
16. Swing the steam wand so that it is facing towards the drip tray. Turn the control dial to
the STEAM position ( ) once more. Let the steam run until a small amount of water has
run through the unit to fully clean out the steam wand of any excess milk.
NOTE:
If you want to brew Espresso straight after frothing milk, make sure the ESPRESSO/
STEAM button is in the highest ESPRESSO position ( ). Turn the control dial to the
Espresso position ( ) to run a small amount of water through the Brew Head for
a few seconds without the Filter Holder in place until the white READY light turns off.
This will prepare the system for optimal brewing temperature. Then follow the Brewing
Fresh Espresso instructions.
Having the ESPRESSO/STEAM button in the lowest STEAM position ( ) when brewing
Espresso could result in a burned coffee taste because of the required higher temperature
for steam.
HEATING
READY
HEATING
READY
Fig. 8
Fig. 9
SZ-314289_CRUX006_15 bar Espresso maker_IM_R3.indd 13
2017-05-17 5:02 PM
