10
11
Before Using For The First Time
CAUTION:
To protect against electrical shock, do not immerse the Coffee Maker or
allow power cord to come into contact with water or other liquids.
1. Remove all packing material and labels from the inside and outside of the Coffee Maker.
Place the unit on a flat, clean surface.
2. Before preparing coffee, thoroughly clean the glass carafe and lid, removable filter holder
and permanent coffee filter in hot, sudsy water. Rinse and dry. Replace disassembled
parts. See Care & Cleaning Instructions for a detailed description.
3. Clean the inside of the Coffee Maker by brewing 2 full carafes of water (see Brewing
Coffee Instructions). Do not add the permanent coffee filter or ground coffee for
this initial cleaning.
NOTE:
At the end of the first cycle, allow 15 minutes for the unit to cool.
4. Brew a second carafe of fresh water.
5. Wait an additional 15 minutes to allow the unit to cool before brewing your
first carafe of coffee.
Brewing Coffee Instructions
1. Lift to open the Coffee Maker lid. Fill carafe with cold water and pour into water reservoir
at the back of the unit. The water level indicator can be easily viewed through the water
gauge on the right side of the unit.
IMPORTANT:
Before brewing, always check to make sure water level is past
the 2 Cup line and add water if needed. Never exceed the MAX fill line.
NOTE:
The amount of brewed coffee will always be less than the amount of water
placed into the water reservoir; as much as 10% is absorbed by coffee grounds and filter.
2. Place empty carafe on the warming plate.
3. Place the permanent filter in the removable filter holder. Measure 1 level tablespoon
of drip or regular grind coffee for each cup of coffee desired. For stronger or
milder coffee, adjust amount of coffee to suit your taste.
4. Drop the filter holder down into the housing. Close the lid.
5. Plug Coffee Maker into a 120V AC electrical wall outlet.
6. Set the switch to the ON (–) position. The Coffee Maker will begin the brew cycle.
NOTE:
To interrupt the brewing cycle at any time, set the switch to OFF (O).
Remove plug from wall outlet.
7. Upon completion of the brew cycle, wait at least 1 minute until the brew dripping
from the filter holder into the carafe has stopped. The carafe lid should be kept in place
to facilitate safe serving and help keep coffee at proper serving temperature. Tilt the
carafe slightly and pour hot coffee very slowly, so that the flow of the brewed coffee
does not exceed the width of the spout.
8. Set the switch to OFF (O) when the carafe is empty or when unit is not in use;
then remove plug from wall outlet.
SO-314133_14634_CRUX_5 cup Manual CM_Macy's_IM_R3.indd 10-11
2017-04-10 8:07 AM