GENERAL OPERATION
7
BILGE PUMP
The bilge pump is located in the rear of the bilge on all models. To activate the
bilge pump, turn the ‘Bilge Pump’ switch ON which is located on the dash switch
panel. When operating the bilge pump always keep an eye on the outlet, when
the water flow stops turn the bilge pump switch OFF. Do not run the bilge pump
dry for any extended period of time as damage to the pump and/or wiring may
occur.
All bilge pumps are fully automatic with a built in sensor to turn on the pump
when the water level becomes too high. Bilge pumps are also wired directly to
the start battery with an in line fuse so they are always active, even if the battery
switch is in the off position.
Fully automatic bilge pump with built in
sensor (no separate float switch)
