Crossfire 1100GT, User Manual

Page: 43 / 113

35
OPERATION
Starting the Engine
1. Sit in the driver's seat and fasten the seat belt.
2. Place the transmission in neutral. Set the parking brake.
3. Apply the brakes.
4. Do not press the throttle pedal while starting the engine.
5. Turn the ignition key to the “ST” position. Engage the starter for a maximum of five seconds.
Release the key when the engine starts.
NOTICE: Operating the vehicle immediately after starting could cause engine damage. Allow the
engine to warm up for several minutes before operating the vehicle.
6. If the engine does not start within five seconds, return the ignition switch to the “ON” position and
wait five seconds. Repeat steps 5 and 6 until the engine starts.
Tip: If a warm engine has cooled to a point where it does not readily start, intermittent use of the
choke (pulled half way out) may be necessary. If the engine is over-choked when warm, depress
the throttle lever fully while cranking to aid in starting. Release the throttle lever immediately
after the engine starts. If the engine does not start and all conditions are favorable, change the
spark plug and try again.
7. Vary the engine RPM slightly with the throttle to aid in warm-up until the engine idles smoothly.
8. Release the parking brake before driving.
1100GT User Manual
35