CCpilot V700
Revision: 1.0
Technical Manual
2020-09-10
www.crosscontrol.com
7
Note that the depth of the threaded holes is 8 mm. Be careful not to use too long screws which
may damage the device when tightened. It is also very important to use a fastening plate with
holes that are not larger in diameter than 6 mm to avoid pulling out the threaded inserts from
the unit.
4.1.1.
RAM mount
CCpilot V700 can be mounted using a RAM mount, i.e. RAM-202U, a round base 1.5” ball
mount which allows adjustment of the display’s position and angle. Screw length should be
12mm.
Figure 5: 3 hole ram mount
4.1.2.
Panel mount
Alternatively, the device can be mounted in a panel-cutout using a panel mounting bracket
(article number C000152-48), Screw length should be 10mm.
