2.7 Installation/Operation
Installing and Operating the 4116-T300 Multi-Band, Block Translator
1. Connect a -40 dBm to -15 dBm signal to L-BAND INPUT, (Figure 2.5).
2. Connect the RF OUTPUT, to the external equipment.
3. Using the pre-assembled AC power input cable (furnished), connect 100-240 ±10% VAC,
47 - 63 Hz to AC IN connector on the front panel.
4. If a custom length power cable must be made, refer to description below for connections*.
5. Be sure DS1 (green, DC Power) is on and DS2 (red, Alarm) is off (Figure 2.5).
6. Set the gain so that the output level is always within the range of -15 to 0 dB.
(See Table 2.0 and 2.6.1).
7. Select either INT (for internal 10 MHz ref), AUTO (for internal 10 MHz ref UNLESS an
external 10 MHz, +2 to +8 dBm signal is connected to J2), or EXT (for external 10 MHz, +2 to +8 dBm
reference that is inserted at J2) via
Ethernet
or serial command. (see Section 2.0 and Table 2.6.1).
8. Check that a 10 MHz, signal is present at the 10 MHz REF OUTPUT at the same level as the input,
±0.5 dB (J4 - Figure 2.5).
9. AC Fuse - The fuse is a 1A/250V 1.25” x .25” (slow blow) and is inserted in the fuse F1 position.
NOTE: If a fuse continues to open, the power supply is most likely defective.
2.7.1 Connection to AC Input Power
The 4116-T300 is furnished with a pre-assembled AC power input cable as described below.
* 4116
* 4116-T300 AC Power Input Connections
Conne
Connector, Clipper Series, CL1M1102 and crimp pins
Mating
Mating Connector, Clipper Series, CL1F1101 and crimp pins
Pin Input Connector Pin Description
1
100-240 ±10% VAC, 47-63 Hz, 20 watts max.
2
Neutral
3
Ground
Unless otherwise specified, the mating connector is provided preassembled onto a
standard NEMA 5-15P U.S. power cord.
4116-T300 Manual_F
Page 19
11/05/15
