Copyright © 2016 The Crosby Group LLC. All Rights Reserved.
Tilting
1. Open the clamp by pulling the latch lever (A) towards the hand grip (X). Place the
clamp securely and as far possible over the profile (8).
2. Release the latch lever, so that the clamp stays in pretensioned position on the
profile. The pivot (C) must be fully in touch with the profile to be lifted (9).
3. Bring the guiding wheel (H) in tilt position. The chain (Z) must be completely
untensioned and always behind the guiding wheel (H). The load can now be lifted
(10).
4. Pull gently the chain taut. By proceeding the lift, the beam will tilt around point R
and will keep on hanging skew as soon as it goes up from the ground. Without too
much effort the beam can be fixed in any desired position when putting down the
beam (11).
5.
As soon as the load is at its destination let the crane hook descend until the clamp
is fully free of load, meaning that the lifting chain is no longer taut (12).
6. Keep the latch lever (A) against the hand grip (X), so that the clamp can be
removed from the load. The clamp may now be used again immediately (13).
1.4
A reliable clamp, a secure basis for lifting
10 Year warranty preventive maintenance procedure:
Parts should be replaced only when they no longer meet our standards.
10 Year warranty repair procedure:
During every repair service the most critical parts, being pivot and camsegment will be
replaced.
Please consult www.crosbyip.com/warranty for more information on maintenance
procedures.
Maintenance without 10 year warranty: Annually clamps are subjected to inspection*
and parts will be replaced only when they no longer meet our standards.
*CrosbyIP authorised repairer
EN
09
