Qlink-3000 Multiplexing modem
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567
Copyright © 2003 -2005 Cronyx Engineering
38
4.8. “Configure” menu
The “
Configure
” menu allows to select multiplexing modem operating modes:
Configure
1. PCLK source: Port 0
2. Mode: CO (Central Office)
3. Port 0...
4. Port 1...
5. Alarm input: Normal
6. SNMP...
7. Remote control: Enabled
8. Factory settings...
9. Save parameters
0. Restore parameters
Command: _
If the current parameters have been set unsuccessfully, the saved configuration may be
restored using the “
Restore parameters
” command. After setting the parameters, you
should save them in the non-volatile memory (NVRAM) using the “
Save parameters
”
command. If required, all settings may be restored to a known initial state using the
“
Factory settings
” menu item.