Crivit 292900, Instructions Manual

Page: 5 / 28

GB 5
t) If you are using the unit on a carpet, make sure
that the air supply to the ventilation holes is suffi-
cient.
u) Only one person may use the unit at a time.
v) Protect the vibration plate against moisture and
water, and ensure that the electrical components
do not come into contact with water.
w) This device is not suitable for pregnant women
and persons with reduced physical, sensory or
mental abilities. Persons who do not have any ex-
perience with equipment such as these need an
explanation on how the machine operates and
how to use before using it for the first time.
x) It is dangerous to reach into the inside area of the
foot plate with your hand.
y) Always make sure that weight is evenly distributed
to avoid damage to the unit and the development
of noise.
3333 LLLL
IST OF PAR IST OF PAR IST OF PAR IST OF PARTS TS TS TS
No. No. No. No. Description Description Description Description ####
1 Remote control 1
2 Display cover 1
3 Display 1
4 Transparent panel 1
5 Upper housing cover 1
6 Centre section of housing 1
7 Phillips screw ST4 x 12 18
8 Base plate 1
9 Plastic connector 2
10 Motor 1
11 Motor mounting bracket 1
12 Main frame 1
13 Bottom plate 1
14 Transport roller 1
15 R clamp 2
16 Cable connection 3
17 Magnetic ring 1
18 Stretch tube with handle (L 60 cm) 2
19 Lower housing cover 1
20 Base supports 4
21 Power cable with power plug 1
22 Power switch 1
23 Fitting for power switch 1
24 Fuse 1
25 Rubber mat 1
26 Hexagonal head bolt M8 x 25 2
27 Motor mounting bracket 1
28 Hook 2
29 Phillips screw ST3 x 10 4
No. No. No. No. Description Description Description Description ####
30 Connecting pin 2
31 Ball bearing sleeve 2
32 Screw M5 x 30 8
33 Nut with nylon insert M8 4
34 Cover for axle mounting bracket 2
35 Axle mounting bracket 2
36 Ball bearing 6201 2
37 Flywheel 1
38 Spring washer ±8 6
39 Hex bolt M8 x 20 2
40 Bushing 1
41 Axle 1
42 V-belt 1
43 Washer ±4 1
44 Insulation 2
Figure A shows the exploded assembly drawing of
your new equipment. Please note that the unit is al-
ready pre-assembled.
4444 IIII
NSTRUCTIONS FOR USE NSTRUCTIONS FOR USE NSTRUCTIONS FOR USE NSTRUCTIONS FOR USE
4.1
4.1 4.1
4.1 General instructions
General instructions General instructions
General instructions
The equipment is already fully assembled. Check that
your new equipment is complete with no parts missing
before using it for the first time. Make sure that you
have emptied the box completely. If, despite our quality
controls, a part or two are missing, please contact our
service centre using the contact details at the end.
4.2
4.2 4.2
4.2 Computer
Computer Computer
Computer
The figure above shows the Touch Screen Control Panel
on the vibration board. The LED display shows, among
other things, the time. A possibly selected training pro-
gram („Program Mode Indicator‰) is displayed below
it.