© 2022 All rights reserved. Data subject to change without notice.
69
Rev. B | 2022.03
LPT-M - Operation Manual
calibrations. It comes in a durable, hard plastic carrying case and includes a
regulator, adapters, humidification chamber, brass fitting, hand tools and tubing.
It does not include cylinders of gas. These must be ordered separately.
Calibration Kits and gases are available from the CETCI factory. Many gases,
but not all are carried in inventory. Check with any CETCI authorized distributor
for availability of specific gas types.
Gas cylinders cannot be shipped from
Canada to other countries, including the USA.
9 MAINTENANCE
The LPT-M transmitter requires virtually no maintenance other than regular
calibration of the sensor(s). There are no replaceable components except the
sensors.
The transmitter should be monitored for possible damaging conditions.
• The sensor vent should be kept free of dirt or soot build up.
• If in a damp location, source of water should be shielded from
contacting the top of the transmitter.
• If located in a working area, the front of the transmitter should
be kept clear.
• If painting is to be done in the same area as the transmitter,
the transmitter needs to be protected from over spray and the
sensor vent should be covered so as to not receive paint fumes.
Paint fumes may damage and / or reduce the life of the sensor.
It is important to ensure that excess water and/or dust is not somehow
entering the enclosure and physically damaging the circuit board or internal
components.
