1.
Remove the distiller from the box;
Note:
it is useful to keep the original box, it can be used later in case you need to return the
device to the distributor/manufacturer for repairs or replacement.
2.
Check if all the components listed below are present:
- tap water container with spring valve cap;
- distilled water container with cap;
- carbon filter;
- base unit;
- water tray;
- main unit;
- filter;
- metal clip.
3.
Place the water tray on the base unit, install the filter over the heating element and
finally fit the main unit on the base unit;
INSTALLING THE FILTER:
A.
Remove the filter from the plastic tray and immerse it in water;
B.
Put it over the heating element (Fig.8) and use the metal clip provided to hold it in
place (Fig.9);
Note:
The function of the filter is to reduce scales (mineral deposits) build up on the heating element
during the distillation process to ensure maximum heating efficiency and performance of the distiller.
The majority of the mineral deposits will adhere to the filter which can be washed and reused.
The filter
must be replaced every other 3 months
or sooner depending on the water quality;
4.
Place the distilled water container on the base unit with the top opening to the back, on
the left. Fill the tap water container with regular tap water, put the valve cap on and fit it on
the base unit;
5.
Allow a minute so the water fills the boiling tray. Plug the distiller into the electric outlet
and press “ON-Reset” on the On/Off switch. At this moment, if the red LED is on, it means
that one of the following situations is happening:
13
HOW TO USE THE CRISTÓFOLI DISTILLER
Fig.8
Fig.9
C R I S T Ó F O L I
D I S T I L L E R
I N S T R U C T I O N M A N U A L
Summary of Contents for Distiller
Page 2: ......
