35
3.3.3
Programming field 2 : Select special mode
BOOST and REFRESH modes are idle by default on the solar charge controller because the solar power source is not
permanent and therefore the MPPT may not complete full battery recharge cycles; which can affect their lifespan. A
solar source is a back-up source, which helps compensate for small battery discharges. The user can, if he likes,
reactivate these modes.
Setting
REFRESH
mode
BOOST
mode
0
OFF
OFF
1
OFF
ON
2
ON
OFF
3
ON
ON
-
The BOOST function allows a faster charging of the batteries. This function is timed in time (see section
3.3.2.) And is automatically inhibited if the battery is charged: shutdown of the BOOST for a battery
current <20% of the nominal current of the MPPT (2A in the case of the Lithium curve Iron Phosphate
with BMS with a minimum time of 10 minutes).
-
The REFRESH function allows to apply a voltage step periodically to maintain the battery, to promote
its equalization and thus prevent possible sulfating.
3.3.4
Programming field 3 : Select Can address
Setting
REGREGULATOR_Frame1
Can address
Setting
REGREGULATOR_Frame1
Can address
0
0x0002 9000
8
0x0002 9008
1
0x0002 9001
9
0x0002 9009
2
0x0002 9002
10
0x0002 900A
3
0x0002 9003
11
0x0002 900B
4
0x0002 9004
12
0x0002 900C
5
0x0002 9005
13
0x0002 900D
6
0x0002 9006
14
0x0002 900E
7
0x0002 9007
15
0x0002 900F
3.3.5
Programming field 4 : offset BOOST voltage
Setting
12V output
Offset in mV
24V output
Offset in mV
0
-400
-800
1
-300
-600
2
-200
-400
3
-100
-200
4
0
0
5
100
200
6
200
400
7
300
600
