OPERATING INSTRUCTIONS - ALARM
Active Arming / Locking:
Press and release button #1 (Lock symbol) on the transmitter. The system will arm and confirm with one siren
chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter disable circuit
will turn on. After a short delay to allow the vehicle and electronics to settle, the system is completely armed.
Disarming: / Unlocking
Press and release button #2 (Unlock symbol) on the transmitter. System will disarm and confirm with two
siren chirps, two light flashes, and the LED will turn off. Power locks will Unlock and Interior Dome light will
turn on (if installed with these optional features)
Disarming While Tripped (Triggered):
Disarming the System while it is triggering requires TWO presses of the #2 Unlock Button. The first press of
Button #2 Resets the alarm cycle only (system still armed) while a second press will disarm/unlock the system.
Silent Arming/Disarming (On demand):
To Arm or Disarm the system without siren chirps, press and release both Buttons #2 (Unlock) and #4 (Start)
at the same time. System will Arm or Disarm without siren chirps that one time. Flashing lights and LED will
be the only indicators of Arm/Disarm status. If the system was tripped while you were away, 4 chirps will be
heard to notify you that the system was tripped.
Silent Arming/Disarming (Chirp Defeat):
This system can be programmed to silent arm and disarm using the normal lock and unlock buttons. Flashing
lights and LED will be the only indicators of armed or disarm status. Check with your installer or follow
programming option instructions in the installation manual.
Remote Panic Protection
To sound the alarm in an emergency situation or to draw attention to your vehicle, press and hold Button #1
(Lock) for at least 3 seconds until the siren sounds. Press Button #2 (Unlock) to reset panic mode.
Driver’s Priority / Split Unlock
(Optional)
When using the optional separate driver’s and passenger unlock function, press and release button #2
(Unlock symbol) on the transmitter to unlock driver’s door only, then press the #2 button again within 2-4
seconds to unlock remaining doors. This feature is optional and requires additional parts and/or labor
Arming With Shock Sensor Bypass
To arm the alarm and bypass shock sensor protection, press Button #1 as normal then press and release
Button #1 and #2 together within 2 seconds. You will hear 3 extra siren chirps indicating shock sensor bypass
for this arming cycle only.
6
