5
WIRING
ORANGE WIRE: (-) NEGATIVE ARMED OUTPUT / STARTER DISABLE (500mA Ground, Optional)
This wire becomes a (-) Ground Output when the System is Armed. This output is used for disabling the
starter or to activate optional devices such as extra sensors, LED’s, window roll-up modules, voice modules
etc. For Starter Kill, cut starter wire and connect between 87A and 30 on relay. Connect orange wire to 85
and connect 86 to an Ignition source that has voltage in the ON and CRANKING position. (See wiring
diagram for relay configuration page 16)
BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)
Connect to RED siren wire from the Siren in the engine compartment.
WHITE WIRE: Two 12V FLASHING LIGHT
OUTPUTS (7.5 Amp x 2)
Connect to the switched parking light wire at back of light switch. If this is not possible, connect directly to one
of the parking lights at the front of the vehicle. Some vehicles require separate right and left circuits. Use the
one White wire for each circuit (Use separate 7.5Amp fuse for each circuit).
RED WIRE: 12V POWER INPUT (15 amp fuse)
Connect to 12 Volt source with supplied fuse & holder. Recommended location for this connection is at the
vehicle battery positive terminal.
2 PIN PLUG (WHITE): VALET PROGRAM and OVERRIDE PUSH-BUTTON
2 PIN PLUG (RED): ALARM STATUS LED INDICATOR
4 PIN SENSOR PLUG (RED):
GREEN Wire:
Negative Trigger.
WHITE Wire:
Negative Warn-A-Way.
BLACK Wire:
Sensor Ground.
RED
Wire:
Sensor 12V Power.
SHOCK SENSOR:
The sensor supplied with
this system does not require any additional
wiring. Simply mount the sensor in a suitable
location, plug it in, and adjust the sensitivity.
SENSOR ADJUSTMENT
Clockwise = Higher Sensitivity
Counter Clockwise = Lower Sensitivity
