Your Crime Guard security system is designed so that an optional accessory
sensor may be easily added. Although several types of sensors are available,
the most commonly used sensor detects impact to the vehicle.
• A heavy impact will fully activate the alarm, sounding the siren, flashing
the lights and relocking the doors.
• If the sensor is a “dual zone” type, the system responds to a light impact
by “Prewarning”, which is chirping the siren three times and relocking all
of the doors.
• Should the Prewarning circuit be triggered five times within a single
armed period, the Prewarning circuit only will automatically shutdown
until the security system is disarmed, and then armed again.
OPTIONAL SENSOR CAPABILITY
THE SIREN WILL CHIRP TWICE
TO CONFIRM ARMING
THE SIREN THEN CHIRPS
ONCE TO CONFIRM
SENSOR BYPASS
THE DOORS WILL LOCK
UPON ARMING
THE PARKING LIGHTS
WILL FLASH TWICE
TO CONFIRM
ARMING
Page 16
Bypassing the Sensor:
If an optional sensor is utilized, and should it be
desired, when the security system is armed the sensor can then be turned off.
BACKUP BATTERY
• When the optional sensor is bypassed; all of the system’s other protected
zones are still operational.
• The optional sensor will remain off until the next time the system is armed
in the regular fashion..
This security system is equipped with a backup battery which will provide
an alternative power source to operate the Crime Guard system should the
vehicle's battery is disconnected.
To Bypass the Optional Sensor:
FIRST- Arm the System normally with the Upper Left
“Lock” Button ( ), THEN within 4 Seconds Press
& Release the Lower Left Button ( )
••
U
While operating on the backup battery, the system will not flash the
parking lights, nor the Status Light. The siren will continue to operate, all
protected entry zones will continue to be monitored, and if equipped, the
optional Starter Interrupt will operate while the system is armed. The backup
battery should be replaced every 18 months, or any time the backup battery
has operated the system on its own. The backup battery is inside the system’s
control module, so it is best replaced by a qualified installer.
Page 17
Your system is equipped with three separately programmable Vehicle
Recovery protection features, which also provide Anti-Carjacking protection.
The Vehicle Recovery operation may be selectively activated by the ignition,
by an open door, or by the transmitter.
How It Works
:
Once the Vehicle Recovery process has begun, the user has 53 seconds to
cancel the process by pressing the Valet Switch once. If Vehicle Recovery
is not cancelled, 53 seconds after being activated the siren will begin to chirp
for 7 seconds to alert the user that the system is about to enter into an alarm
condition. The Valet Switch may still be pressed once during this period to
cancel the Vehicle Recovery process.
If the Vehicle Recovery process is not cancelled before the 60 second
countdown expires, the system will enter an alarm condition, sounding the
siren and flashing the parking lights. 30 seconds after this occurs, or should
the ignition be turned off in the meantime, the stater interrupt will engage.
Once the system enters the alarm condition, it will not respond to the
transmitter, nor will the system reset automatically after 60 seconds, and it
can only be disengaged by:
VEHICLE RECOVERY
Level #1: Vehicle Recovery activated by the vehicle’s ignition:
The Vehicle Recovery process is started every time the vehicle’s ignition is
turned on. This is programmable feature #14.
Step 3
Within 5 seconds, perform an Emergency Override using the
Valet Switch. If the SecureCode has been customized, the correct
number of Valet Switch presses must be made (page 22).
Step 2
Turning the ignition back on.
Step 1
Turning the vehicle’s ignition off.
