Crestron
TPS-ENETL
Ethernet Card for TPS/Lectern Panel
7. Tighten the card mounting screws to
finger-tight
.
CAUTION:
The TPS-ENETL connector may have to be aligned slightly
to fit through the opening in the rear cover. Align the connector of this
card (or any other optional card that is installed)
carefully
to prevent
damage to the card, cover, or touchpanel.
8. As shown on the below, install the touchpanel rear cover by
sliding it over the TPS-ENETL connector.
Install Touchpanel Rear Cover
9. Refer to the diagram on next page. Re-install the
10
rear cover
screws to
finger-tight
then, using a #1 Philips screwdriver,
tighten an additional
1/8-turn
.
Operations & Installation Guide - DOC. 6013
Ethernet Card for TPS/Lectern Panel: TPS-ENETL
•
9
