Crestron
TPS-6X-DSW
Wall Mount Docking Station for TPS-6X
Removal
If it is necessary to remove the TPS-6X-DSW after it has been installed, complete
the following steps in the order provided. The only tool required is a #2 Phillips
screwdriver.
1. Undock the touchpanel. Refer to “Undocking the Touchpanel” which starts
on page 14 for details.
2. Push the TPS-6X-DSW mechanism backward, into the box, until it locks in
place, exposing the screws securing the bezel on the left and right sides.
(Refer to illustration on previous page.)
3. Remove the screws and washers, two from the left side and two from right
side, which secure the bezel and gently remove the bezel from the
TPS-6X-DSW.
4. Remove the screws, two from the top and two from the bottom, which
secure the TPS-6X-DSW to the back box. (Refer to illustration on page 11.)
5. If necessary, secure and label the attached cables before disconnecting them
from the TPS-6X-DSW.
Hardware Hookup
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to “Network Wiring” on page 8 before attaching the 4-position
terminal block connector. Apply power after all connections have been made.
When making connections to the TPS-6X-DSW, use Crestron power supplies for
Crestron equipment.
Hardware Connections for the TPS-6X-DSW
NET:
TO CONTROL
SYSTEM AND
OTHER CRESNET
DEVICES
LAN:
10BASE-T/100BASE-TX
HIGH SPEED ETHERNET
VIDEO IN (UNBL):
UNBALANCED
VIDEO INPUT
VIDEO IN (BAL):
BALANCED
VIDEO INPUT
Operations & Installation Guide – DOC. 6708A
Wall Mount Docking Station for TPS-6X: TPS-6X-DSW
•
13
