Crestron
Touch The PC Driver
Software
NOTE:
A Crestron TPS-ENET or TPS-ENETL Ethernet expansion card must be
installed in the touchpanel to enable Ethernet communication. For further
information, refer to the TPS-ENET or TPS-ENETL Operations & Installation
Guide (Doc. 6016 or 6013, respectively). The latest revisions can be obtained from
the Downloads | Product Manuals section of the Crestron website
(
). New users are required to register to obtain access to the FTP
site.
NOTE:
The Crestron control system must contain an Ethernet expansion card to
enable Ethernet communication. On CNX Generation control systems, the port may
be labeled LAN or LAN/DPA. On 2-Series control systems, the port may be labeled
LAN A or LAN B. For further information about CNX Generation Ethernet cards,
refer to the CNXENET or Operations & Installation Guide (Doc. 8129
or 8153, respectively). For further information about 2-Series Ethernet cards, refer to
the C2ENET-1/-2 Operations & Installation Guide (Doc. 5962). The latest revisions
can be obtained from the Downloads | Product Manuals section of the Crestron
website (
).
Cabling Connections
For Touch the PC V2 operation using Ethernet communication with the PC, refer to
the steps below.
1. Refer to the appropriate (for TPS-XVGA, TPS-XVGA-BV, or TPS-
XVGAL card) diagrams and tables which follow and make the cable
connections.
Ethernet Communication #1 - Tilt Touchpanel with TPS-XVGA
TO
RGB
PORT
RGB CABLE
PC
LAN
PORT
ETHERNET
WIRING
COM
PORT
CONTROL
SYSTEM
ETHERNET
ROUTER/HUB
COM
PORT
TILT TOUCHPANEL
WITH TPS-XVGA
VGA
PORT
A
COMM. CABLE
B
D
C
LAN
PORT
POWER
PACK
E
24VDC
2.0A
PORT
B KLT
MENU
PROFESSIO NAL CONTRO L PRO CESSOR
PRO
2
C RESTR ON
PORT
CONNECTOR to CONNECTOR
DEVICE
PORT
A
1
VGA
DB-15, male
DB-15, male
Touchpanel
RGB
B
2
COM
DB-9, female
DB-9, female
Control System
COM
C
3
LAN
RJ-45, 8-pin
RJ-45, 8-pin
Ethernet / Hub
na
D
3
na
RJ-45, 8-pin
RJ-45, 8-pin
Touchpanel
LAN
E
4
na
na
Touchpanel
24VDC 2A
1
2
3
4
REF
ETHERNET COMMUNICATION #1 - TILT TOUCHPANEL WITH TPS-XVGA CARD
CABLING REQUIRED
TO
DEVICE
PC
Standard Ethernet cables (ref C & D).
Standard stranded VGA monitor cable.
PC
Standard null modem serial cable.
FROM
Ethernet / Hub
PWR. PACK
Control System
Power pack (PW-2420RU) is NOT required if power is supplied via Cresnet.
Programmer’s Guide – DOC. 5916B
Touch the PC Driver
•
9
Summary of Contents for Touch The PC Driver
Page 4: ......
