Mud Mount Kits
Crestron
MMK-2000L & WMKM-2000L
NOTE:
Do not over tighten screws. Doing so may over-dimple or rip the mud ring
plate.
9. Use a #2 Phillips screwdriver and tighten the drywall screws by hand
so that they slightly dimple into the holes in the mud ring plate.
10. Apply drywall joint compound as needed to finish the cutout.
11. When dry, the TPS-2000L can be installed using the four tapped holes
in the PMK-2000L. Refer to the latest revision of the TPS-2000L
Operations Guide (Doc. 5972) for details.
WMKM-2000L Procedure
The procedure in this section provides the necessary steps for the assembly and
installation of the WMKM-2000L into a wall. Complete the steps in the order
provided. The only tools or materials required and not supplied are a drywall saw or
equivalent, a level, four standard drywall screws, #2 Phillips screwdriver, and
tools/material to apply drywall joint compound.
1. Insert the two pins on one fastener plate into the top two outer holes on
the mounting plate, as shown in the illustration after this step.
Create the Fastener/Mounting Plate Assembly
FASTENER PLATE
QUANTITY 2
PUSH-ON
FASTENER
QUANTITY 4
MOUNTING
PLATE
QUANTITY 1
2. Slid two push-on fasteners over the pins on the fastener plate to loosely
secure the fastener plate and the mounting plate. Do not push the push-
on fasteners all the way down onto the pins. Slid them on enough to
keep the fastener plate and mounting plate as one fastener/mounting
plate assembly.
3. Use the second fastener plate and repeat steps 1 and 2 on the opposite
side of the mounting plate.
4
•
Mud Mount Kits: MMK-2000L & WMKM-2000L
Installation Guide – DOC. 6025
