CRESTRON GREEN LIGHT
®
EXPRESS
Power Switching Cabinet GLPX-HSW-FT
Testing
Ma
Ligh
To t
and t
rele
NO
ram may change the settings if the
Override
mode is not enabled
.
nual Control
ting modules can be manually controlled from the front panel.
oggle the output between off and on, tap the appropriate
ON/OFF
button. The corresponding LED illuminates
he output state is shown on the
NET ID
display (“oF” for off, “On” for on) for two seconds after the button is
ased.
TE:
The control system prog
Ov
The
valu
ttings, refer to “Save Override Settings” below.
To e
NOTE:
erride Mode
Override
mode overrides the control system program and sets all of the output states to the stored override
es. For instructions on saving override se
nable
Override
mode, press and release the
OVR
button. The
OVR
LED flashes slowly.
If the
Override
mode was enabled from an external device (i.e. a contact closure is present on the
OV
flash quickly. Pressing the
OVR
button has no effect.
ERRIDE
terminals), the
OVR
LED will
To disable
Override
mode, press the
OVR
button again. The
OVR
LED extinguishes and the outputs return to the
states set by the control system program.
NOTE:
If override states have not been stored, the factory default override state is all loads on.
Save Override Settings
The
mod
NO
an prevent locally saving the override state. If this setting is
state of each output can be saved as an override setting, which can be automatically recalled when the
Override
e is enabled.
TE:
The control system program has a setting that c
enabled, the display shows “Er” when trying to save override states. For more information, refer to the SIMPL
Windows help file.
To save the states of all outputs as the override setting, press and hold the
OVR
button for three seconds until the
LED blinks once. The
OVR
LED blinks to indicate the new override setting has been stored.
System Operation and Commissioning
This cabinet has been des
ponent of a programmed Crestron system. System commissioning by an
authorized Crestron representative
must
igned as a com
be performed to ensure system operation.
Once t
[1-8
ssioning.
he cabinet has been wired and the modules have been tested, contact Crestron at 1-888-CRESTRON
88-273-7876] to schedule commi
Installation Guide – DOC. 6888B
GREEN LIGHT
®
EXPRESS Power Switching Cabinet GLPX-HSW-FT
•
11
