3. Push the module down into the appropriate module slot in the
FT2-ELEC assembly so that the module slides into place. Use the guide
ribs on the front and rear of the module to help position the module in
the assembly.
4. Route the module’s power cable through the wire saddle on the
retractor, and then connect the cable to the retractor as shown in the
following illustration.
CAUTION:
If the FT2A-CBLR-1T series pass-through module or
retractor must be removed from the FT2-ELEC assembly,
disconnect the module power cable from the retractor prior to
removal.
7
FT2A-CBLR-1T Series
Quick Start
FlipTop™ One-Touch Cable Retractors
