3. Once all devices have been acquired, take the gateway out of
Acquire mode. Refer to the gateway’s manual for details.
Leaving an infiNET EX Network
To leave an infiNET EX network, put the device into Acquire mode, as
described in
when no gateway is in Acquire
mode.
Verifying Communications Status
To check the communications status of the device, tap the SET button
three times and then press and hold it down (tap-tap-tap-press+hold) for
up to 2 seconds. The LED flashes to indicate the communications status.
Refer to the following table for details.
LED
Communications Status
Turns on for 5
seconds
The device is communicating with the control system.
Flashes twice
The device was previously joined to the network but is not
communicating with the gateway.
Flashes once
The device is not joined to the network.
LED Diagnostics
The LED flashes to provide a visual reference that the motor is operating
normally or if it is in an error state.
Normal Operation
The following table provides a list of possible LED patterns encountered
during normal operation. All LEDs extinguish after 1 minute of inactivity if
there are no errors to report.
LED Patterns
LED Pattern
LED
Color
Operating Mode
Two fast flashes, then pause
(1/8-second on, 1/8-second off,
1/8-second on, 5/8-second off)
Blue
A firmware upgrade over
the Cresnet® network is
in progress.
Slow flash (1/2-second on, 1/2-second
off)
Blue
The motor’s internal
firmware upgrade is in
progress.
Solid
Blue
The motor is in
Bootloader mode.
Fast flash (1/4-second on, 1/4-second
off)
White
The motor is in
Identify mode.
Slow flash (1/2-second on, 1/2-second
off)
Green
The motor is moving
from a local button
press.
Solid
Green
The motor is
communicating with the
control system program.
Slow flash (1/2-second on, 1/2-second
off)
Red
The motor is not
communicating with the
control system.
15
CSA-DECOR5 Series
Quick Start
Shade Motor Bracket Installation and Motor Programming
