Crestron
CNX-TS
Single Gang Temperature Sensor
7. In the "Command Complete" window, click
OK
.
8. In
the
Current Network Devices
text window, verify the new
NET ID code.
9. In the "Set Network ID" window, click
Close
.
NOTE:
The new NET ID code may also be verified by selecting
Diagnostic | Report Network Devices
in the Viewport (alternately,
select
F4
).
10. Repeat this procedure for each sensor to be added to the
system.
Installation
Tools/hardware required
Temperature sensor and faceplate (supplied)
Cresnet network cable
Phillips screwdriver
Two 3/16 in. flathead phillips screws (supplied)
Insulation (not supplied)
NOTE:
The insulation will protect the sensor from any in-the-wall
conditions (such as drafts, etc.). Use type in compliance with local codes.
After the Cresnet network wiring has been installed and verified, use the
following procedure to install the sensor (refer to illustration on page 4)
in a single gang electrical box.
1. Turn Cresnet system power
OFF
.
2. Connect the Cresnet cable with supplied mate to the sensor’s
Cresnet port and the other end to the control system.
3. Insert insulation in electrical box (make sure it fills void of
box not occupied by sensor).
CAUTION:
Excess wire that is pinched between the sensor and
electrical box could short out. Make sure that all excess wire is
completely inside the electrical box and not between the box and the
sensor. The CNX-TS contains an electrostatic sensitive device (ESD).
Observe precautions for handling ESDs to avoid damaging unit.
Operations & Installation Guide - DOC. 8191
Single Gang Temperature Sensor: CNX-TS
•
7
