Crestron C2N-TTVFM, Operation Manual

Page: 14 / 44

TV & FM Radio Tuner Crestron C2N-TTVFM
10
•
TV & FM Radio Tuner: C2N-TTVFM Operations Guide - DOC. 6266A
There are two different methods—Method A or Method B—for setting the
C2N- TTVFM Net IDs:
Method A (Cresnet address-settable ID), described below, applies to C2N-TTVFMs
in a Cresnet system with a CNX control system or with a 2-Series control system
upgrade file (CUZ) version prior to 3.008, but can be used with later versions of
firmware and requires that a single unit be the only network device connected to the
control system.
Method B (Touch Settable IDs), which begins on this page, applies to
C2N-TTVFMs in a Cresnet system with 2-Series control system upgrade file (CUZ)
version 3.029 or later. These upgrades enable Touch Settable ID (TSID)
functionality, which makes it possible for the control system to recognize a network
device via its serial number, which is stored in the device’s memory. This method
does not require that any devices be disconnected from the network; Net IDs may be
set with the entire Cresnet system intact. This method requires the use of the
Crestron Viewport version 3.35 or later.
Use the appropriate method to set the C2N-TTVFM Net ID.
Method A (Cresnet address-settable ID)
1. Ensure that the C2N-TTVFM is the only device connected to the
control system.
2. Open the Crestron Viewport.
3. From the Viewport menu, select Functions | Set Network ID . The
software checks the baud rate and then opens the "Set Network ID"
window.
4. In the "Set Network ID" window, select the TV/FM Tuner from the
Current Network Devices text window.
5. Select the new Net ID for the TV/FM Tuner from the Choose the new
network ID for the selected device (Hex): text box.
6. Click Set ID to initiate the change. This will display the "ID command
has been sent" window.
7. In the "Command Complete" window, click OK .
8. In the Current Network Devices text window, verify the new Net ID
code.
9. In the "Set Network ID" window, click Close .
NOTE: The new Net ID code may also be verified by selecting Diagnostic |
Report Network Devices in the Viewport (alternately, select F4 ).
10. Repeat this procedure for each TV/FM Tuner to be added to the
system.
Method B (Touch Settable IDs)
Before using this method, you should have a list of all current network devices and
their Net IDs, to avoid assigning duplicate IDs.
Set Net ID by TSID
These procedures are for TSID-enabled network devices during the initial
configuration of a Cresnet system or when such devices are being added/replaced.