Crestron C2N-TTVFM, Operation Manual

Page: 11 / 44

Crestron C2N-TTVFM TV & FM Radio Tuner
Operations Guide - DOC. 6266A TV & FM Radio Tuner: C2N-TTVFM
•
7
Front Panel Controls and Indicators
Ten LED indicators, a five-digit display, and three pushbutton switches are located
on the front panel of the TV/FM Tuner. Refer to the illustration and descriptions that
follow.
C2N-TTVFM Front Panel Controls and Indicators
PWR (Power)
This green LED illuminates when power is supplied to the TV/FM Tuner.
NET
This yellow LED illuminates when communication between the control system and
the TV/FM Tuner is established (the unit is polled on the network). Illumination
indicates that the program currently loaded has a network device defined at the same
ID as the TV/FM Tuner. The LED flashes or remains on when communication with
the processor occurs.
BAND Switch
Use the BAND switch to select between the AM, FM, WX (weather), and TV bands.
The corresponding red LEDs ( AM , FM , WX, TV ) illuminate as each band is selected,
and the five-digit display shows the appropriate values. The AM and WX modes
cannot be selected if the AMWX Tuner is excluded from your configuration.
MODE Switch,
KJ
(Up/Down) Buttons, and Display
Use the MODE switch to select between the volume, preset, tune, and scan modes.
The corresponding red LEDs ( VOL , PRE , TUNE , and SCAN ) illuminate as each
mode is selected. In each mode, the five-digit display shows the appropriate values.
In the volume mode, the up/down buttons select ten volume levels (0 through 9) for the
signal supplied to the headphone jack.
In the preset mode, the up/down buttons let you sequence through the preset numbers
(1-20) to select a station or to save a new station in a preset location.
In the tune mode, the up/down buttons let you sequence through the FM band
frequencies in 100 kHz increments. (The frequency scan and step rate can be changed
via the program from 100 kHz to 50 kHz, the rate needed in European radios.) For
the TV band, the buttons let you sequence through all available channels.
In the scan mode for all bands, the up/down buttons initiate the scan and direction of
the search for the next station with a signal strong enough for good reception. Pressing
either button will halt the scan.