2 of 4
CI380X05R4_B
SURFACE MOUNT
STEP 1:
Using the provided mounting plate, mark the
intended installation surface with the bolt
pattern. Bolt hole diameter is 0.332". See
Figure 3.
STEP 2:
Using (4) 5/16"-18 customer supplied
fasteners grade 5 or better secure the fitter
to the mounting surface. See
Figure 4.
STEP 3:
Route the supply cord from the luminaire
through the Fitter. See
Figure 4.
STEP 4:
Mount luminaire to fitter using (4) 3/8"-16
supplied fasteners. See
Figure 4.
STEP 5:
Make electrical connections per
Electrical
Connection
section.
DIRECT MOUNT TO POLE
STEP 1:
Using the provided mounting plate, mark the
pole with the bolt pattern. Bolt hole diameter
is 0.332". See
Figure 3.
NOTE:
Bolt hole diameter may be increased
to 9/16" for round poles. Verify clearance with
other pole hardware prior to drilling.
STEP 2:
Insert the Square Mounting Plate into the top
of the pole as seen in
Figure 7.
STEP 3:
Using (4) 5/16"-18 supplied fasteners secure
the fitter to square mounting plate.
STEP 4:
Route the supply cord coming from the
luminaire through the Fitter and then through
the pole. See
Figure 7.
STEP 5:
Complete Steps 4 and 5 of the Surface Mount
Instructions.
UPLIGHT MOUNTING
STEP 1:
Remove (2) 3/8” - 16 X 1.5” hex bolts located
in the top section of the Mounting Clamp. See
Figure 5.
STEP 2:
Remove Mounting Clamp and flip the
luminaire so that the LEDs are pointing
upwards. See
Figure 5.
STEP 3:
Reinstall the Mounting Clamp, ensuring that
the (2) hex bolts are installed on the same
side as the LEDs. See
Figure 6.
STEP 4:
Retighten the (2) hex bolts that were removed
in Step 1 to 150 in. lbs. See
Figure 6.
STEP 5:
Install luminaire to mounting surface
referencing mounting procedures above.
2X
2.625
66.68
5.000
127
3.000
76.20
2.500
63.50
1.500
38.10
2X 1.000
25.40
0.50
12.70
2X 1.313
33.34
PLATE
HEIGHT
DRILL
DIAMETER
POLE
CENTER LINE
PLATE WIDTH
3
4
Fitter
(4) 5/16"-18
Customer Supplied
Fasteners
(4) 3/8"-16
Supplied Fasteners
Supply Cord
5
6
(2) 3/8" - 16 X 1.5" Hex Bolts
Mounting Clamp
Mounting Clamp
(2) 3/8" - 16 X 1.5" Hex Bolts
NOTICE: LEDs are
Pointing Upwards
