CREATOR CHINA
2013-09
WWW.CREATOR1997.COM
6
WiFi Conference System U
ser„s Manual
navigation panel (including the ACTIVE MICRO
'S‟, BASS, TREBLE, VOLUME) are of the same.
2.4.1.1 SYSTEM ENQUIRY Menu
In the menu of MENU, press the “
” or “ ”
direction key to select sub-menu "SYSTEM
ENQUIRY", then press "ENTER" button to enter
the system inquiry.
In the "SYSTEM ENQUIRY" menu, press the “
”
or “ ” direction key to query the number of all
the conference units when the system was
constructed, and the number of conference units
to
which
wireless
AP
access
device
correspondingly connected.
The queried information is the parameter
information when the system was constructed,
so as to facilitate the system setting and
maintenance, rather than that of the current
real-time connection status.
2.4.1.2 ID ENQUIRY Menu
In the menu of MENU, press the “
” or “ ”
direction key to select sub-menu "ID ENQUIRY",
then press "ENTER" button to enter the ID inquiry.
Press the “
” or “ ” direction key in the "ID
ENQUIRY" menu to query the assigned ID value
of each conference unit when the system was
constructed.
2.4.1.3 CAMERA Menu
In the menu of MENU, press the “
” or “ ”
direction key to select the submenu "CAMERA",
then press "ENTER" key to enter the automatic
camera tracking settings.
In the "CAMERA" menu, press the
“
” or “ ”
direction key can choose "Protocol" and "Preset"
options. Then press "ENTER" key to enter the
corresponding settings.
You should first enter into the "Protocol" to select
the corresponding camera protocol. Support
CREATOR DEF (standard return code of
CREATOR
conference
system),
PELCO-D,
PELCO-P and VISCA. The unified baud rate of
protocols is 9600bps.
After select the appropriate protocol, return to the
previous layer menu, enter "Preset" setting of
camera, and then bind the preset of the camera
with the unit ID to realize the camera tracking.
In the "Preset" menu, select "SET", then enter the
camera preset settings; select "CALL", then enter
the camera preset recall state.
For detailed operating, please refer to
camera preset setting procedures in the later
part.
2.4.2 AFC Key Operation
Automatic frequency control function setting:
press "AFC" button on the controller panel, so as
to start the automatic frequency control function,
at the same time the key lamp is lit up. Press
"AFC" button again, button lamp is off, and the
automatic frequency control function is closed.
The setting methods of "ANC" anti-noise function
and "AGC" microphone auto gain control function
are similar to "AFC" operation method.
2.4.3 ID Key Operation
ID key is used to control WIFI conference system
enter or exit ID setting function when the system
is under construction.
Long press "ID" key for 5 seconds, the ID key
indicator stay lit, LCD display "SYSTEM SETING",
suggest it has entered the ID setting function. In
this state, pressing the “
” or “ ” direction key
can query the total number of meeting units of
currently set ID, and the number of meeting units
connected with the wireless AP access device.
Short press or long press the "ID" key, can exit
the ID setup and enter the normal working state.
For detailed operating, please refer to the
below ID setup instructions.
