CREATOR CHINA
2013-09
WWW.CREATOR1997.COM
20
WiFi Conference System U
ser„s Manual
controller, it can directly enter into the system ID
setting status, and the green indicator of MI rod is
lit. If the unit has not connected to the controller,
then you need to open the power switch of the
unit and press the microphone on/off key
simultaneously, until enter into the ID setting
status, and rod green indicator is lit.
According to this method, one by one to confirm
all the units have entered into the system ID
setting status.
Step4, performing setting operations
1, Press the volume increasing or decreasing key
on SSID selection interface of the unit , so as to
select the corresponding SSID of wireless AP
access device to which the unit is connected to.
Press the microphone switch key for confirmation,
and then the unit began to search for a wireless
AP access device, with rod red indicator lit.
2, if the search is failed, or it cannot connect to
the corresponding wireless AP access device, it
will return to SSID selection interface, with
microphone rod green indicator lit.
If it is connected to the corresponding wireless AP
access device, then it can be assigned IP, MI rod
red indicator extinguished, and it automatically
start RF pairing operation with RF wireless digital
audio sender.
If RF pairing is successful, then the unit
loudspeakers issue a long continuous "Du ~ ~ ~";
If RF pairing is failed, then the unit loudspeakers
issue continuous short "Du Du Du ~ ~ ~".
If the pairing is not successful, then click the
microphone switch key once again to reform a
pairing operation, until the pairing is succeeded.
3, According to the above method, finish all the
units‟ settings one by one.
Here you must make sure the unit
loudspeakers issue a long continuous "Du ~ ~
~"before proceeding to the next unit operation,
so as to avoid setting error which increases
the workload.
Step5 Complete the system ID setting
After the completion of the system settings of all
units, click the "ID" button on WIFI conference
controller front panel, then you can complete and
exit system setup.
The unit machine automatically exits the system
settings, and began to work normally.
5.2 Automatic Camera Tracking
Settings
WIFI conference system controller supports
automatic camera tracking function. It supports
CREATOR conference system standard protocol,
camera protocol of PELCO-D, PELCO-P and
VISCA as well.
The automatic camera tracking settings must be
done after completing the system ID setting of
WIFI conference unit. Otherwise is invalid. The
specific steps are as follows:
Step1,System connecting
Connected to CREATOR camera tracking
controller, or third party controller through RS-232
interface, WIFI conference controller can realize
control. It can directly connect to camera to
control.
WIFI conference controller fixed the baud rate of
RS-232 as 9600bps, the settings of camera or the
third party equipment shall be consistent with this.
When
WIFI
conference
controller
directly
connects to the camera, it can only control one
camera.
Step2, Control protocol selection
Select "CAMERA" on the WIFI conference
controller front panel MENU, press "ENTER" to
