Page 7
©
Copyright 2005, Creative Playthings. Printed in U.S.A.
19716-400 Rev C (11-20)
9 Ft. Swing Beam
ASSEMBLY INSTRUCTIONS
STEP 13 – Install Gym Brace
(Not required for Ridgefield, Yorktown, Manchester or
Norfolk gyms).
Fasten the Gym Brace (D) to the end of Gym Base Extension (C)
using two 5/16 x 4" Hex Bolt Assemblies, as shown.
Secure the Gym Brace to the Corner Post using one 3/8 x 4"
Lag Screw and one 3/8" Flat Washer through the top hole on
the Gym Brace. (Drill 1/4" diameter pilot hole in the Post for the
Lag Screw).
STEP 14 – Hang Swing Accessories
Chain extensions are required to lower the Swing Accessories
to a usable height. Attach the extra chain to the ends of the
swing chains using the included Quick Links. Securely tighten
the Quick Links using a wrench.
Hang the Swings and Trapeze in the positions shown on the
cover of this document. Follow the instructions included with
each accessory.
STEP 15 – Hole Caps
Tighten all the hardware. Install the two 1" Hole Caps in the
counter-bored holes on the Leg Brace. Install four 1" Hole Caps
in the counter-bored holes on the Base Rail Anchor. Install two
1" Hole Caps in the counter-bored hole on the bottom of the
Gym Brace and one 1-1/2" Hole Cap in the counter-bored hole
on the top of the Gym Brace.
Quick Link
C
D
Special Note: two Spring Hooks have been included for use
in place of two of the quick links to quickly swap swing ac-
cessories.
