14
Frequency
You can detune oscillator 2 and 3 with oscillator 1. The scale
shows the amount of detune in half tone steps with a
maximum of 9 half tone steps.
OSC 3 Control
It is possible here to separate oscillator 3 from the keyboard
(’s frequency input). Oscillator 3 acts then as sound element
with a fixed frequency, for example, as an LFO. When
oscillator 3 is used as an LFO, you can adjust its speed with
Range for coarse alterations and with Frequency for finer
alterations.
Oscillator Modulation
Here, you can activate pitch modulation for all three
oscillators. The signal, adjusted within the Modulation Mix
works as a modulation source. This can be either oscillator 3,
noise or a mixer of both. The modulation wheel and its
parameters can adjust the intensity. (Shown in the Modulation
Wheel Settings under the Remote Software)
MIXER
In this section, all signals are
mixed before they go through the
Filter. The signals are oscillator 1
through, the noise generator and
an external signal. That is
altogether six sound sources
including filter oscillation, directly
produced by the filter. Every
sound source has a specified
knob to adjust the volume and an
on/off switch. It is in addition
possible if wanted or needed, to distort external signals.
Volume
Here you can adjust the volume of each oscillator.
External Input Volume
This controls the volume for external signals. In order to hear
a signal, you need to connect the MINIMAX ASB Audio-Input
with an external sound source. The view control is above the
volume slider. The louder the signal, the brighter is the light.
Summary of Contents for MINIMAX ASB
Page 1: ...1 Owners Manual MINIMAX ASB ...
