Creality CR-Laser Falcon, User Manual

Page: 15 / 20

在线工作 Real-time working
In preview mode, press microswitch again, it enters engraving mode. At this time, the laser head will emit
strong light, the machine will start engraving with indicator light on.
Pause engraving: press the microswitch (or click “Pause” button in the software). At this time, the indicator
light turns into breathing light. Press the microswitch again to continue engraving.
Cancel engraving: Please press and hold the microswitch for 3 seconds (or click “Cancel” button in the
software), it will “beep” once, starts to reset, and “beep” twice after reset is completed. Enter standby mode, the
indicator light turns into breathing light.
After engraving is completed, it will “beep” three times and reset. After reset completed, it “beep” twice,
enters standby mode, and the indicator light turns into breathing light.
关于 Type-C 实时工作，请参考 TF 卡中的随机资料。
For real-time working by Type-C, please refer to the tutorial in the TF card.
3. 雕刻完成后，机器会长“滴”三声，随后机器复位，复位完成机器发出“滴 ... 滴”两声，进入待机模式，指示灯变成呼吸灯效果。
Press the microswitch, it enters preview mode from standby mode,
the laser head will emit weak light, and repeat movement around the
largest X, Y edge of the processed picture with indicator light on. At this
time, adjust the material to a suitable position.
2. 按下微动开关，机器从待机模式进入预览模式，激光头会发出弱光，并围绕所加
工图片的最大 X、Y 边缘重复运动，指示灯常亮。此时可以调整材料至合适位置。
预览模式下，再次按下微动开关，机器进入雕刻模式，此时激光头会发出强光，机器开始雕刻，指示灯常亮。
如果需要暂停雕刻，请按下微动开关，此时指示灯变成呼吸灯效果，再次按下微动开关可以继续雕刻。
如果需要取消雕刻，请长按微动开关 3 秒，机器会发出“滴”一声，随后机器复位，复位完成机器发出“滴 ... 滴”两声，进入待机模
式，指示灯变成呼吸灯效果。
微动开关