VCIOM-05044
Page 56 of 75
DIgITal EPIC-2 TEChnICal Manual
InstallatIon and operatIng InstructIons
To generate a new Maintenance Signature,
from gen new Signature screen, scroll to
“Start Maint” and press SElECT. The screen
above will appear asking if you wish to continue.
use the Down arrow key to select between
“no” or “Yes” and then press SElECT. If “no”
is selected, it will return to the previous screen
without performing the signature. If “Yes” is
selected, the signature generation will start
with the next screen below.
7.3.4.3.1.1.4 Generate maintenance signature
This is the top level sub-menu to view Full-
Stroke Run-Time Data. Since all Full-Stroke
Signature contain both an Open and a Close
signatures, this is further divided into sub-
menus to view either Open or close data.
From the FST Sign Menu, scroll down to
“Runtime Data” to view critical signature data
stored on the device, then press SElECT.
7.3.4.3.1.2 Run-time data
The screen above will show the progress of the
signature by showing x% complete. Once 100%
is reached, it will be complete and the next
screen should appear.
Once the Maintenance Signature completes, if
successful, the screen above should appear. If
not successful, it will show an error stating the
problem. The problem will also be logged in
the alert File which can give more information
as to the root cause and how to resolve it. Once
the problem is resolved, try again. To view
the Maintenance Signature see section View
Maintenance Signature.
Copyright © Crane Co. All rights reserved.
