11
The three recessed head cap screws (33) can now be
removed from the motor mounting plate (34). Remove the
mounting plate (34), hydraulic motor (6) and retainer (23). If
motor (6) is being replaced, remove mounting plate (34) by
removing screws (35).
F-4.2) Reassembly:
Assemble motor (6) to mounting plate (34) by inserting
screws (35) into the inner two holes and tightening. Insert
motor and mounting plate into frame (5). Place retainer (23)
onto mounting plate from the opposite end of frame (5) and
insert three screws (33) in the outer holes and tighten. To
assemble discharge case (22) to frame (5), set the assembly
in the upright position. Apply a grease to o-rings (19) and
(20) and place discharge case (22) onto the frame assembly
lining up the holes. Insert cap screws (31) with washers
(30), into holes and torque to 75 In Lbs. Place o-rings (25)
and (26) in the appropriate locations (see Fig,s 7 or 9, for
internal or external operation), on the hydraulic fi ttings (2).
Insert hydraulic fi ttings (2), through discharge case (22) and
into motor (6) and tighten, by placing wrench on the fl ats
located on fi tting. Assemble lower end of pump per Sections
F-3 and F-2.
SECTION: G REPLACEMENT PARTS
G-1 ORDERING REPLACEMENT PARTS:
Your local Prosser distributor can supply parts and repair
service. When ordering parts, ALWAYS furnish the following
information: Specify pump model number as shown on
nameplate, serial number, part number, item number and part
name.
1. Pump serial number. (G-1)
2. Pump model number. (G-2)
3. Part description.
4. Item part number.
5. Quantity required.
6. Shipping instructions.
7. Billing Instructions.
G-1 SERIAL NUMBER:
The Serial Number block will consists of a six digit number,
which is specifi c to each pump and may be preceded by
a alpha character, which indicates the plant location. This
number will also be suffi xed with a three or four digit number,
which indicates the date the unit was built (Date Code).
EXAMPLE: A012345 495
Reference the six digit portion (Serial Number) of the number
when referring to the product.
G-2 MODEL NUMBER:
This designation consist of numbers which represent, Pump
Line, Horsepower, Motor phase, Voltage and Variations
(as shown below). This Number is used for ordering and
obtaining information.
