Crane BevMax 4, Technical Manual

Page: 32 / 103

31
Transformer (T1) Provides 24 Volt
power to the
Controller Board.
Service Door Switches
If 2 Switches - Left Switch
(10 Amp) – in XY Motor
Circuits, Port Door Motor Circuit, and Picker Motor
Circuit (Power Interrupt Switch).
If 2 Switches - Right Switch
(.1 Amp) – in
Controller and Electronic Lock Circuit (Lock Switch).
If One Switch
- the red & black wires are in
Controller Circuit and the two gray wires are go to
XY Motor Circuits, Port Door Motor Circuit, and
Picker Motor Circuit. (Power Interrupt Switch).
General Maintenance
The most important facets of proper care and
maintenance of your machine are the electrical
power supplied to it, leveling, and cleanliness of the
machine.
POWER
Domestically the machine must be connected to a
dedicated 120 VAC, 15 Amp circuit (U.S. and
Canada). Refer to the cabinet serial number plate to
determine the correct voltage and frequency for the
machine.
CAUTION:
REMOVE POWER TO THE AC DISTRIBUTION
BOX BEFORE CLEANING OR WHEN ANY
ELECTRICAL COMPONENTS ARE CONNECTED /
DISCONNECTED FOR TESTING OR
REPLACEMENT.
Periodically inspect the power supply
cord for damage. If the cord or plug is
worn or damaged, it must be replaced
with a power supply cord of the same
type, size and specification as originally
provided with the machine. DO NOT
USE THE VENDING MACHINE UNTIL
THE WORN OR DAMAGED CORD IS
REPLACED.
The Ground Fault Circuit Interrupter (GFCI) must be
tested frequently and before each use in accordance
with the instructions provided on the GFCI device.
IF THE GFCI DOES NOT PASS THE TEST, DO
NOT USE THE MACHINE.
Unplug the supply cord
from the receptacle and call the Crane
Merchandising Systems Technical Support Group
for assistance at 1-803-266-5001.
CAUTION:
REMOVE POWER TO THE AC DISTRIBUTION
BOX BEFORE CLEANING OR WHEN ANY
ELECTRICAL COMPONENTS ARE CONNECTED /
DISCONNECTED FOR TESTING OR
REPLACEMENT.
CLEANING
DO NOT USE A WATER JET OR NOZZLE TO
CLEAN THE VENDER
GLASS DOOR
The display glass should be cleaned inside and
out with paper towels and glass or non-abrasive
all-purpose cleaner. The gasket around the
product door should be wiped down using warm
water, any mild general purpose, non-abrasive
cleaner and a soft towel. Never lubricate the
gasket and always check for cracking or
deformities which may cause leaks. Replace if
necessary.
VERTICAL LAMP LENS COVER
Then vertical lamp lens covers are of a
polycarbonate material. Clean as needed with
warm water only. Ammonia or alcohol based
products will damage the lens cover.
TRAYS / TRAY INSERTS
The trays and tray inserts should be cleaned
periodically using warm water and a mild
general purpose, non-abrasive cleaner. Care
should be taken to ensure debris does not enter
the gear box assemblies.
DO NOT USE
SOLVENTS OR ABRASIVE MATERIALS TO
CLEAN ANY PORTION OF THE TRAY.
DOOR LIGHTING
The machine is designed with an energy
efficient T8 Lighting System or LED Lighting
System. To ensure continued reliable operation,
replace only with the same type and size lamps.
Lamps must be properly installed and seated in
the lamp holders.
SLIDE/PUSHER ASSEMBLY
The slide/pusher assembly should be cleaned
periodically using warm water and any mild
general-purpose non-abrasive cleaner. After
drying, the slide assembly needs to have a coat
of Armoral applied. Care should be taken to
ensure debris does not enter the gear box
assemblies.
DO NOT USE SOLVENTS OR
ABRASIVE MATERIALS TO CLEAN ANY
PORTION OF THE TRAY.