13
IMPORTANT ! - DO NOT hammer on the seal
pusher- it will damage the seal face.
Make sure the stationary member is in straight. Slide a
bullet (see parts list-seal tool kit) over motor shaft. Lightly
oil
(DO NOT use grease)
shaft, bullet and inner surface of
bellows on rotating member (17b) see Fig. 7. With lapped
surface of rotating member (17b) facing inward toward
stationary member (17a), slide rotating member (17b) over
bullet and onto shaft, using seal pusher, until lapped faces
of (17a) and (17b) are together (see Fig. 7).
IMPORTANT ! - It is extremely important to
keep seal faces clean during assembly. Dirt
particles lodged between these faces will
cause the seal to leak.
Place spring (17c) over shaft and in place on rotating
member (17b), making sure it is seated on retainer and not
cocked or resting on bellows tail. Slide retaining ring (17d)
over shaft and let rest on spring (17c). Assemble impeller,
cutter and volute as outlined in paragraph F-3.2.
SECTION: G REPLACEMENT PARTS
G-1 ORDERING REPLACEMENT PARTS:
When ordering replacement parts, ALWAYS furnish the
following information:
1. Pump serial number and date code. (Paragraph G-4)
2. Pump model number. (Paragraph G-3)
3. Pump part number. (Paragraph G-2)
4. Part description.
5. Item part number.
6. Quantity required.
7. Shipping instructions.
8. Billing Instructions.
G-2 PART NUMBER:
The part number consists of a six (6) digit number, which
appears in the catalog. A one or two letter suf
fi
x may follow
this number to designate the design con
fi
guration. This
number is used for ordering and obtaining information.
G-3 MODEL NUMBER:
This designation consists of numbers and letters which rep-
resent the discharge size, series, horsepower, motor phase
and voltage, speed and pump design. This number is used
for ordering and obtaining information.
G-4 SERIAL NUMBER:
The serial number block will consist of a six digit number,
which is speci
fi
c to each pump and may be preceded by
a alpha character, which indicates the plant location. This
number will also be suf
fi
xed with a four digit number, which
indicates the date the unit was built (Date Code).
EXAMPLE: A012345 0490
.
Reference the six digit portion (Serial Number) of this num-
ber when referring to the product.
Rotating Member (17D)
Bullet
Motor & Intermediate
Seal Pusher
Stationary
FIGURE 7
Summary of Contents for Barnes XSGV 2 HP
Page 15: ...15 FIGURE 8 2HP XSGV SERIES ...
Page 16: ...16 FIGURE 9 2HP XSGV SERIES ...
Page 18: ...18 FIGURE 10 3 5 7 5HP XSGV SERIES ...
