Crane Barnes SE411HT, Installation Manual

Page: 4 / 16

4
DISCHARGE ............................. 2” NPT, Female, Vertical
LIQUID TEMPERATURE .......... 200°F (93°C) Continuous
VOLUTE ..................................... Cast Iron ASTM A-48, Class 30
MOTOR HOUSING .................... Cast Iron ASTM A-48, Class 30
SEAL PLATE ............................ Cast Iron ASTM A-48, Class 30
STRAINER ........................... Steel
IMPELLER: Design ................ 2 Vane, Open with pump out
vanes on back side. Dynamically
Balanced, ISO G6.3
Material ............. Cast Iron ASTM A-48, Class 30
SHAFT ...................................... 416 Stainless Steel
SQUARE RINGS ....................... Buna-N
HARDWARE .............................. 300 Series Stainless Steel
PAINT ......................................... Air Dry Enamel
SEAL: Design .............. Single Mechanical
Reservoir, Secondary Exclusion
Seal
Material .............. Carbon/Ceramic/Buna-N
Hardware -300 Series Stainless
CORD ENTRY ........................... 15 ft. (5m) Cord with plug On 115
volt and Stainless Wire Mesh
Strain Relief, Pressure Gromment
for sealing and strain relief
SPEED ....................................... 1750 RPM (nominal)
UPPER BEARING ...................... Single Row, Ball, Oil Lubricated
LOWER BEARING ..................... Single Row, Ball, Oil Lubricated
MOTOR: Design ............... NEMA L Torque Curve, Oil Filled,
Squirrel Cage Induction
Insulation .......... Class F
SINGLE PHASE ......................... Permanent Split Capacitor (PSC)
Includes Overload Protection in
Motor
PUMP SPECIFICATIONS SERIES:
inches
(mm)