19
Change Power Off Time
This setting sets the Auto Power of time on the wrench. This is highly recommended if the wrench isn’t docked
in the cradle between jobs and if multiple wrenches are being used with 1 TCI. The more wrenches on and
paired to the TCI, the greater the RF interference in that area.
Change Feedback Start Point
When using the “Targeting LED and Vibration” indication while pulling setting this changes at which point the
feedback on the wrench begins. This allows the user to delay indication to begin later in the cycle. For the
majority of cases the default setting of 10% will be optimal but in rare occasions (for example a really large
wrench on a really soft joint) this may be adjusted up to 50% to push all the feedback towards the end of the
cycle.
Change Open Protocol Port
This setting changes the TCP/IP port used to connect to the control the TCI via Open Protocol for this particular
wrench.
