28
ENGLISH
This saw features a dust chute for convenience in
discharging sawdust. A standard utility vacuum can be
attached to the dust extraction port on dust chute ,
located under the back side of the saw cabinet.
During periods of extended use, the dust chute should be
emptied and cleaned to prevent buildup of sawdust and to
make sure there are no obstructions that could hinder
maximum performance.
•
Turn saw off and unplug saw.
•
Loosen the screw at the left side of the dust chute .
•
Open the small baffle .
•
Shake out any sawdust and wipe with a clean dry cloth,
as needed.
•
Replace the small baffle and securely tighten the
screw .
To clean the dust chute:
•
Unlock the bevel locking lever
.
•
Loosen the 0° set screw
(located at the left of the
bevel track on the front) with 4 mm hex key (not
supplied).
•
Place a framing square (not supplied) beside the
blade on the right. The edge of the square and the
saw blade should be parallel.
•
Lock the bevel locking lever .
•
Tighten the 0° set screw
.
Check again for squareness
and continue to adjust if needed.
If the blade is not perfectly vertical (0°) (Fig. 37a-37b):
1
2
1
3
1
2
1
1
2
3
4
4
4
3
2
1
3
1
3
4
4
2
Dust collection (Fig. 36)
ADJUSTMENTS
WARNING:
Before performing any adjustment, make
sure tool is unplugged from power supply and switch
is in off position. Failure to do so could result in serious
personal injury.
WARNING:
Make sure the blade guard is reinstalled
immediately after making any adjustment which
requires it to be removed. Failure to heed this
instruction could result in serious personal injury.
Fig. 36
Fig. 37a
Fig. 37b
This saw has positive stops that will quickly position the saw
blade at 90° (0°) or 45° to the table. Angle settings of saw
have been set at the factory and, unless damaged in
shipping, should not require setting during assembly. After
extensive use, they may need to be checked.
To set the blade at 0° and 45°
(Fig. 37a-37d)
•
Turn saw off and unplug saw.
•
Raise the blade to the maximum height by turning the
height adjusting handle clockwise.
•
Remove the anti-kickback pawls and blade guard.
NOTICE:
Make sure that the square contacts the flat part of
the saw blade, not the blade teeth.
CAUTION:
It is strongly recommended to connect a
dust collection system to the dust extraction port.
WARNING:
Table saw must be regularly checked for
dust built up and cleaned frequently, otherwise there
is a risk of heat built up and potential fire.
