0
1
2
3
4
5
6
7
8
9
10
11
12
0
0
1
1
2
3
4
5
6
7
8
9
10
2
3
4
5
6
7
8
9
10
11
12
16
ENGLISH
2
3
4
2
1
7
5
3
6
Miter gauge installation (Fig. 12)
The miter gauge can be installed on each miter gauge
groove on either side of blade.
• Slide the guide rail
of the miter gauge into one of
the guide grooves of the saw table intended for this
purpose.
NOTICE:
Care should be taken to position hoses to not
interfere with cutting operation.
Connect to a dust collection system
(Fig. 14)
The dust extraction port with a standard 2 1/2" (63.5mm)
diameter is located on the rear of the table saw. This port
can be connected directly to a dust collection system by
connecting the pick up end of the dust collection hose to
the dust port.
Fig. 13a
Fig. 13b
Fig. 14
1
2
To store the table saw accessories
(Fig. 13a-13b)
• The table saw has two convenient storage areas (one on
either side of the saw) specifically designed for the saw’s
accessories: rip fence , sub fence assembly , push
stick , anti-kickback pawls , miter gauge , blade
guard and blade wrenches .
• When not in use, unplug the saw and store accessories
securely.
1
2
3
4
5
6
7
3
2
1
1
2
1
1
2
1
3
Ensure the locking handle secures the rip fence in place. If
adjustment are needed, see “To check the tightness of the
rip fence locking handle” in the adjustment section.
Fig. 11
Fig. 12
CAUTION:
It is strongly recommended to connect a
dust collection system to the dust extraction port.
WARNING:
Table saw must be regularly checked for
dust built up and cleaned frequently, otherwise there
is a risk of heat built up and potential fire.
