INSIDE
CORNER
ENGLISH
25
•
Set the bevel angle at 0° and the miter angle at 45° to
either the left or the right. (For making 90° corners.)
•
Nest and secure the crown molding against fence
using a spring clamp (not supplied) and hold crown
molding securely.
•
Before turning on the saw, perform a dry run of the
cutting operation to make sure that no problems will
occur when the cut is made.
•
Grasp the saw handle firmly. Squeeze the switch trigger.
Allow several seconds for the blade to reach maximum
speed.
•
Slowly lower the blade into and through the crown
molding.
3
2
1
1
2
3
CROWN MOLDING FLAT ON MITER TABLE
Bevel Angle
Setting
0°
Type of Cut
Left side, inside corner
1. Top edge of molding against fence
2. Miter table set right 45°
3. Save left end of cut
0°
Right side, inside corner
1. Bottom edge of molding against fence
2. Miter table set left 45°
3. Save left end of cut
0°
Left side, outside corner
1. Bottom edge of molding against fence
2. Miter table set left 45°
3. Save right end of cut
0°
Right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 45°
3. Save right end of cut
NOTICE:
Do not attempt to cut molding that is larger than
5-1/4 in. (133 mm) tall.
Nesting crown molding against the miter
fence (Fig. 36a-36b)
Fig. 35
Fig. 36a
Fig. 36b
CEILING
W
A
L
L
38°
52°
FENCE
MITER TABLE
Bottom edge against fence =
•
Right side, inside corner
•
Left side, outside corner
FENCE
MITER TABLE
Top edge against fence =
• Left side, inside corner
• Right side, outside corner
Bottom edge
against fence
OUTSIDE CORNER
Summary of Contents for CMXEMAX69434501
Page 2: ......
