ENGLISH
13
8
11
3
5
1
9
10
7
5
Fig. 14b
Fig. 14a
Fig. 14c
Fig. 14b
Fig. 14a
WARNING:
Make sure the flanges are clean and
properly arranged. Lower the blade into the lower
table and check for any contact with the metal base
or the miter table.
NOTICE:
Do not touch the tips of the blade teeth with the
square.
1
2
4
2
5
6
4
3
CAUTION:
Your product's miter cut and bevel cut
angles have been preset at the factory but can and
will be misaligned by rough handling and
transportation. It is essential that your new miter saw
be realigned before use. Please adhere to the following
resetting instructions.
CAUTION:
If the saw has not been used recently,
recheck blade squareness to the fence and readjust if
necessary.
•
Unplug the saw.
•
Set the bevel and miter angles to 0°.
•
Lower and lock the saw head in the “DOWN” position.
•
Removing the sliding fence.
•
Place a framing square against the fence and saw
blade .
ADJUSTMENT
Squaring the blade to the fence
(Fig. 15a-15b)
•
If the blade is not 90° to the fence, loosen the four fence
locking bolts with the wrench (supplied).
•
Adjust the fence to be 90° to the blade and tighten the
four fence locking bolts .
•
After fence has aligned, replace the sliding fence, using
a scrap piece of wood, make a cut at 90° then check
squareness on the piece. Readjust if necessary.
1
2
3
4
4
5
Summary of Contents for CMXEMAX69434501
Page 2: ......
