ENGLISH
11
1
2
1
2
2
2
1
2
Fig. 9
Fig. 11
Fig. 12
Fig. 10
NOTICE:
The dust outlet also accepts 11/2 " (38.1 mm)
vacuum hose.
3
1
1
2
WARNING:
In some operations, the workpiece clamp
assembly may interfere with the operation of the
blade guard assembly. Always make sure there is no
interference with the blade guard prior to beginning
any cutting operation to reduce the risk of serious
personal injury.
WARNING:
Do not use this saw to cut and/or sand
metals. The hot chips or sparks may ignite sawdust
from the bag material.
A dust bag is provided for use on this miter saw. It fits
over the dust outlet on the back of the saw.
Install the dust bag (Fig. 9)
A wrench is included with this saw. One end of the
wrench is a phillips screwdriver and the other end is a
hex key. Use the hex key end when installing or
removing blade and the phillips end when removing or
loosening screws. A storage area for the wrench is
located on the left back of the miter saw base.
Wrench (Fig. 10)
•
Loosen the slide lock knob counterclockwise, then
push the slide bar forward or backward. The slide bar
should always be locked in position by tightening it
clockwise when transporting or storing.
•
The slide lock knob is located on the right of the bevel
arm.
Unlocking the slide bar (Fig. 12)
•
Loosen the fence lock knob counter-clockwise.
•
Slide the sliding fence to the end of the slot and
remove it from the slot.
Remove and install sliding fence (Fig. 11)
Remove sliding fence:
•
Loosen the fence lock knob counter-clockwise.
•
Insert the sliding fence into the slot and slide the
fence to the desired position.
•
Tighten the fence lock knob .
Install sliding fence:
Fig. 8
1
2
1
1
2
1
1
1
2
1
1
2
2
Summary of Contents for CMXEMAX69434501
Page 2: ......
