10
OPERATION
Shift Lever
The shift lever is located on the right side of the handle panel. Place
the shift lever into any of eight positions to control the direction of travel
and ground speed.
Forward
Your snow thrower has six forward (F) speeds, with position number
one (1) being the slowest speed.
reverse
Your snow thrower has two reverse (R) speeds, with position number
one (1) being the slower speed.
Choke Control
Activating the choke control closes the choke plate
on the carburetor and aids in starting the engine.
Primer
Depressing the primer forces fuel directly into the
engine’s carburetor to aid in cold-weather starting.
Oil Fill
Engine oil level can be checked and oil added through the oil fill.
Ignition Key
The ignition key is a safety device. Insert key and
snap in place; do not turn ignition key. Pull the key
out halfway to stop the engine. Remove key when the
unit is not in use.
Figure 7
Now that you have set up your snow thrower for operation, get acquainted with its controls and features. These are described below and
illustrated in Figure 7. This knowledge will allow you to use your new equipment to its fullest potential.
NOTE: For detailed starting instructions and more information on all engine controls, refer to the engine manual packed with your unit.
Skid Shoe
Drive Control
Auger Control
Shift Lever
Chute
Assembly
Clean-Out
Tool
Augers
Chute Directional
Control
Engine Controls
* Optional
Starter Handle
Oil Drain
Muffler
Oil Filler Cap/Dipstick
Electric start button*
Electric Switch Box*
Fuel Fill Cap
Primer
Ignition Key
Throttle
Choke
