12
AUGER BELT
• Make sure the auger belt is correctly assembled to
the snow thrower. The belt must pass over the top
of the auger pulley and then twist 1/4 turn to pass
un der neath the two side idler pulleys on the snow
thrower. The "V" side of the belt must seat in the
grooves of all three pulleys. See fi gure 22.
FIGURE 22
VIEWED FROM REAR
IDLER
PULLEY
AUGER PULLEY
TWIST
1/4 TURN
TWIST
1/4 TURN
IDLER
PULLEY
ASSEMBLING THE BELTS
IMPORTANT:
The tapered "V" section of the belts must
be seated into the grooves of the V-pulleys.
DRIVE BELT
• Remove the two
out side
1/8" hairpin clips which are
assembled to the L.H. and R.H. tension ad just ing
chains outside of the clutch idler as sem bly frame.
(The clips will be reinstalled after both belts have
been as sem bled.)
Do not remove
the 3/32" hairpin
clips as sem bled to the chains on the
inside
of the
as sem bly frame. See fi gure 21.
• Assemble the drive belt onto the tractor's engine
pulley and then onto the upper rear pulley on the
clutch/idler assembly. Keep the fl at idler pulley on the
outside of the belt. See fi gure 21.
Hold this diagram above you while viewing the
Clutch/Idler Assembly from underneath the
tractor. Right and left in this diagram will be the
reverse of the view er's right and left.
FIGURE 21
VIEWED FROM UNDERNEATH
1/8"
HAIRPIN
CLIP
ENGINE
PULLEY
LEFT SIDE
OF TRACTOR
RIGHT SIDE
OF TRACTOR
DRIVE V-BELT
FLAT
IDLER
PULLEY
1/8"
HAIRPIN
CLIP
