4. Hanging Bracket Installation.
Turn off circuit breakers to current fixture from breaker
panel and be sure operating light switch is turned to the
OFF position.
WARNING
: Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING
: When using an existing outlet box, be sure the
outlet box is securely attached to the building structure and
can support the full weight of the fan. Ensure outlet box is
clearly marked "Suitable for Fan Support." If not, it must be
replaced with an approved outlet box. Failure to do so can
result in serious injury.
CAUTION
:
Be sure outlet box is grounded properly and that a
ground wire (
GREEN
or bare) is present.
Partially loosen screws in slotted holes on opposite sides of
canopy. Remove the other 2 screws--
save for later use
. Twist
canopy to remove hanging bracket from canopy.
Install hanging bracket to outlet box, using original screws,
spring washers and flat washers provided with new or
original outlet box.* Arrange electrical wiring around the
back of the hanging bracket and away from the bracket
opening.
*
Note
: It is very important that you use the proper hardware
when installing the hanging bracket as this will support the fan.
page 3
ON
OFF
ON
OFF
3. Installation Preparation.
To prevent personal injury and damage,
ensure that the hanging location allows the
blades a clearance of 7 feet (2.13m) from the
floor and 30in. (76cm) from any wall or
obstruction.
This fan is suitable for room sizes up to
400 square feet (37.2 square meters).
Installation requires these tools:
Phillips screwdriver, flathead screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
downrod
installation
flushmount
installation
12f
t - 20f
t
12ft - 20ft
(3.66m - 6.1m)
7 feet
(2.13m)
(76cm)
30
inches
This fan can be mounted with a
downrod
on a regular (no-slope) or vaulted ceiling. The
hanging length can be extended by
purchasing a longer downrod (0.5in./1.27cm
diameter). Other installation, such as
flushmount
, is
not
available for this fan.
blade edge
(3.66m - 6.1m)
hanging bracket
spring washers
outlet box screws
flat washers
Vaulted ceiling
angle is not to
exceed 19 degrees.
