page 7
8. Blade Assembly.
WARNING
: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades. If
overtightened, blades may crack and break.
Locate 15 blade attachment screws/washers in
hardware pack. Locate 15 blade attachment screws
and washers in hardware packs. Hold blade arm up to
blade and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first and
then tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor. Slide blade arm through one of
the openings on motor housing, aligning holes in
blade arm with holes located on the underside of the
motor housing--
refer to drawing at right
.
Attach blade
arm with blade arm screws/lock washers. Before
securing screws permanently, repeat this procedure
with the remaining blade arms. Securely tighten all
screws.
Note
: Tighten blade arm screws twice a year.
blade
blade attachment
screws/washers
blade arm screws/
lock washers
blade arm
opening
Place the light kit fitter on its base to
disassemble it. Remove finial, hex nut and
rubber washer. Carefully lift the glass shade
cage from the light kit fitter base. Now,
carefully remove the glass shade and set in
a safe place for later use.
[”Light Kit Assembly” continued on next
page.]
finial
hex nut
rubber washer
glass
shade
cage
glass
shade
light
kit fitter
9. Light Kit Assembly.
light
kit fitter
base
