page 8
9. Light Kit Assembly.
Remove 1 screw from fitter plate (on the
underside of the motor housing) and partially
loosen the other 2 screws.
Connect
WHITE
wire from light kit fitter to
WHITE
wire from motor housing. Connect
BLACK
wire from the light kit fitter to
BLACK
(or
BLUE
) wire from the motor housing. Be sure
that the molex connections snap together
securely.
Align slotted holes in light kit fitter with
loosened screws on fitter plate. Twist light kit
fitter to lock. Re-install screw that was
previously removed and then securely tighten
all 3 screws.
Install 3 candelabra base 60 watt max. bulbs
(included).
Important
: When replacing bulbs, please allow
bulbs and glass shade to cool down before
touching.
Remove finial, finial plate and threaded washer
from threaded rod on light kit fitter
and save
for later use.
Align hole in glass shade with threaded rod
and push up gently until threaded rod comes
through hole. Secure glass shade with
threaded washer that was previously removed.
Do NOT overtighten threaded washer as glass
may crack or break
. Align hole in center of finial
plate with threaded rod and push up.
Re-attach finial being careful to
NOT
overtighten as glass may crack or break.
molex connections
fitter plate
bulb
light kit fitter
glass shade
finial
motor housing
finial plate
threaded
rod
threaded
washer
