Time Saver:
Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 15 blade attachment screws and
washers in a hardware pack. Slide blade
into slot on side of motor housing, then
align holes in blade with holes in blade
plate which can be seen from underside of
motor housing. Insert 3 blade attachment
screws (along with washers) with fingers
first then tighten screws securely with
Phillips screwdriver. Repeat for remaining
blades.
NOTE
: Tighten blade arm screws twice a
year.
page 7
8. Blade Assembly.
motor housing
blade plate
blade attachment
screws and washers
blade
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screw heads in
bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
hanging bracket
screw
screw
canopy cover
canopy
