page 6
6. Wiring. (cont.)
7. Canopy Assembly.
hanging bracket
canopy
Remove 2 screws on underside of hanging bracket.
Lift canopy to hanging bracket. Align holes in
canopy with holes in hanging bracket. While holding
canopy in place, slide anti-sway adapter up to
canopy. Align holes in anti-sway adapter with holes
in bottom of canopy and then re-insert the screws
that were previously removed. Tighten both screws
securely.
screw
anti-sway
adapter
(optional use)
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
green/
bare
ground
outlet box
wall
control
(wiring for wall control)
plate
1
2
3 4
5
6
12
3
4
D
ON
O
PLEASE NOTE:
Wall and/or remote conrol must
be used for fan to operate. If you do not wish to
use the wall control, please proceed to Section 7
below to continue with fan installation.
IN ORDER TO WIRE WALL CONTROL
, remove
existing wall switch. Wire the
WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
WARNING
:
CONNECT WIRES IN THE FOLLOWING
ORDER ONLY!
Connect
GREEN
ground wire to ground from
house or directly to one of the screws from the
outlet box.
Connect one
BLACK
wire from wall control to
BLACK
(hot) lead wire from house. Connect
second
BLACK
wire from wall control to
BLACK
load wire to fan.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate
to wall control using 2 screws provided in the wall
control.
